Origami Animals

How to Fold an Origami Owl

Step-by-step instructions for an easy kite-base origami owl, with night owl color ideas, a white belly reveal, ear tufts and uses for cards and Halloween.

On this page
  1. What you need
  2. Step-by-step: folding a kite-base owl
  3. Night owl color and detail ideas
  4. Troubleshooting
  5. Variations and uses
  6. FAQ

This origami owl is built on the kite base, one of the simplest starting shapes in origami. It takes about ten minutes, needs only one square and no cutting, and uses paper with a different color on each side to show a pale belly and beak. In dark paper with bright eyes it makes a good “night owl” for autumn and Halloween decorations.

What you need

  • One square of paper. Use paper that is colored on one side and white or pale on the other. A 15 cm (6 inch) square is a good size.
  • Eyes. Round white or yellow stickers, or a white gel pen and a black marker.
  • Optional: a bone folder or fingernail for sharp creases.

Color advice for a night owl: navy, black, dark brown or deep purple with a white reverse gives the best contrast. The dark side becomes the wings and head, and the white side shows as the belly and beak. Yellow or orange eyes stand out well against dark paper.

Step-by-step: folding a kite-base owl

Make the kite

  1. Crease the center. Place the square colored side down, turned so it looks like a diamond. Fold the left corner to the right corner, crease, and unfold. You now have a vertical crease from the top corner to the bottom corner.
  2. Fold the kite. Fold the lower-left and lower-right edges in so they lie along the center crease. The colored side shows on these two flaps, which will become the wings. The top part of the paper stays white.

The kite’s two side corners and the tops of the folded flaps should all sit at roughly the same height. If they don’t, your edges aren’t quite on the center line.

Open the belly

  1. Fold the flap edges back out. Take the inner edge of the left flap, where it meets the center crease, and fold it back outward along a slanted line. The line should start close to the bottom point and run up to a spot a little way out from the center at the top of the flap. Repeat on the right. A white V-shaped belly now shows between the wings.

Make these folds narrow at first. You can widen them later if you want a bigger belly.

Fold the head and beak

  1. Fold the top down. Fold the top corner down along a horizontal line that joins the two side corners of the kite. The colored back of the paper now shows as a downward-pointing triangle over the top of the belly. This triangle is the owl’s head and face.
  2. Fold the beak. Fold the tip of that triangle back up by about a finger’s width. A small white triangle appears, which is the beak.

Finish the base and add eyes

  1. Square off the bottom. Fold the bottom point up behind the model so the owl has a flatter base and a rounder body. How far you fold it changes the owl’s proportions: fold more for a short, round owl, or less for a tall one.
  2. Make the ear tufts. The two top corners of the head already read as ear tufts. For sharper tufts, fold a thin sliver of each upper side edge behind, just below the corner. This narrows the head and makes the corners more pointed.
  3. Add the eyes. Stick or draw two large round eyes on the head triangle, one on each side just above the beak. Large eyes close together look most owl-like.

Night owl color and detail ideas

  • Classic night owl: navy paper, white belly, yellow eyes with black pupils.
  • Halloween owl: black paper with an orange reverse, orange eyes.
  • Barn-style owl: tan or light brown paper with a cream reverse. Leave off the ear tufts by folding the top corners behind.
  • Snowy owl: white paper with a few small dark marks drawn on the wings, and yellow eyes.
  • Feather marks: a few small V shapes drawn on the white belly suggest feathers without overwhelming the design.

Troubleshooting

  • The belly is lopsided. The fold-back lines in step 3 aren’t matching. Unfold both and refold them so they start at the same point near the bottom.
  • There’s no white beak. The paper may be colored on both sides. Use paper with a white or pale reverse, or draw the beak on.
  • The head triangle is crooked. Line up the horizontal fold in step 4 with both kite corners before creasing.
  • The owl looks too long. Fold more of the bottom point behind in step 6.

Variations and uses

  • Sizes. A 7.5 cm square makes a small owl for cards and gift tags, and a 20 cm square makes one large enough for a wall display.
  • Owl family. Fold several sizes from the same paper and line them up on a branch drawn on card.
  • Bookmarks. Glue a small owl to the top of a strip of card.
  • Halloween garland. String black and orange owls together with paper bats or pumpkins.
  • Classroom crafts. The owl only needs simple valley folds, so it works well for groups of children once the center crease is done.

If you enjoyed this model, the easy origami cat and origami rabbit are at a similar level. For more animals sorted by difficulty, see the origami animals guide.

FAQ

Is this origami owl suitable for beginners?

Yes. It uses only valley and mountain folds, with no reverse or squash folds. The step that needs the most care is lining the edges up with the center crease in the kite fold.

Can I make the owl stand up?

This is a flat model. To display it standing, glue it to a folded card, or tape a small triangle of card behind it as a stand.

What does “night owl” mean in origami instructions?

It usually refers to an owl folded or decorated for a night-time look: dark paper, bright eyes, and often a Halloween or autumn theme. The folding method is the same as for any simple owl.

The complete guide to origami animals

Origami Animals: Step-by-Step Models from Easy to Advanced
Read the guide

Keep exploring

Guides from other topics

All topics →