To make origami step by step as a beginner, pick a simple model and use a square of thin paper, about 15 cm (6 inches) across. Fold on a hard, flat surface and follow the steps in order. Line up the edges and corners exactly before you press each fold flat, and crease firmly with a fingernail. Before you try the next step, compare your paper with the picture or description of the step you just did. Start with models of under ten steps, learn the valley fold and mountain fold first, and add new folds one model at a time.
The rest of this guide covers that process in more detail, with a complete first model you can fold right now.
What you need to start
- Square paper. Standard origami paper (often called kami) is thin, crisp and usually colored on one side. A pack of 15 cm squares is inexpensive and covers almost every beginner model.
- Or homemade squares. Fold one corner of a sheet of printer paper down to the opposite edge, crease, and trim off the extra strip. Printer paper is thicker than origami paper but fine for simple models.
- A hard, flat surface, such as a table, a hardback book or a clipboard.
- Optional: a bone folder (or just a fingernail) for sharp creases, and a marker for drawing faces.
The basic folds and diagram symbols
Most origami instructions use a shared set of diagram symbols. The system is generally credited to Akira Yoshizawa, and it was later popularized in English by Samuel Randlett and Robert Harbin. You only need a few of them to start.
| Fold or symbol | What it means | How it usually appears |
|---|---|---|
| Valley fold | Fold the paper toward you so the crease sinks like a valley | Dashed line |
| Mountain fold | Fold the paper away from you so the crease rises like a ridge | Dash-and-dot line |
| Fold and unfold | Make a crease, then open it again to use as a guide | Arrow that goes out and comes back |
| Turn over | Flip the paper over | Looped arrow |
| Inside reverse fold | Push a point inside itself so it changes direction | Hollow “push” arrow plus a fold line |
| Squash fold | Open a flap and flatten it into a new shape | Hollow arrow at the flap’s opening |
Valley and mountain folds are the same fold seen from opposite sides. Turn a valley fold over and it becomes a mountain fold.
Your first model, step by step: an origami dog face
This dog face needs about four main folds. It teaches the two habits that matter most: lining up corners exactly and creasing firmly.
- Place the paper. Put the square colored side down, turned so a corner points toward you. It looks like a diamond.
- Fold a triangle. Fold the top corner down to meet the bottom corner. Line the corners up exactly, hold them in place, then press the fold flat from the middle outward. The folded edge is now at the top.
- Mark the center. Fold the triangle in half from left to right, crease, and unfold. You now have a center line to help keep the ears even.
- Fold the ears. Fold the left corner down along a slanted line so it hangs beside the face, with the tip pointing down. Do the same with the right corner, using the center crease to check that both ears match.
- Shape the snout. Fold just the front layer of the bottom point up by about 2 cm to make a blunt nose. Fold the back layer’s point behind so it doesn’t stick out.
- Flatten the head. Fold a narrow strip of the top edge behind to give the head a flat top.
- Add a face. Draw two eyes, and color in the nose at the bottom tip.
That’s a complete origami model. If your ears came out uneven, fold another one; the second attempt is almost always neater.
How to follow any origami diagram
These habits help with any model, from a dog face to a dragon:
- Read one step ahead. Look at the next picture before folding, so you know what shape you’re aiming for.
- Align, then crease. Match corners and edges exactly first. Only then press the fold flat, starting in the middle and working outward.
- Pre-crease difficult folds. For reverse folds and squash folds, fold and unfold the line first so the paper knows where to go.
- Watch the reference points. Diagrams tell you where a fold should land: a corner, an edge or an existing crease. Folds that land “somewhere near” add up to a messy model.
- Count the layers. When an instruction says “the top layer” or “the front flap,” fold only that layer.
- Check the result. After each step, compare your paper’s outline with the diagram. Catching a mistake right away is much easier than fixing it ten steps later.
What to fold next: a beginner progression
Each model below adds roughly one new skill:
- Cat face. Similar to the dog face, with the ears folded up instead of down. See how to fold an easy origami cat.
- Bunny face. Practice in judging fold angles to get long, even ears. See how to fold an origami rabbit.
- Owl. Introduces the kite base and folding layers back out to show the paper’s other color. See how to fold an origami owl.
- Fox face and two-piece fox. Your first inside reverse fold, for the tail. See how to fold an origami fox.
- Tiger. The same reverse fold, plus drawing patterns. See how to make a tiger with origami paper.
- Long-neck dinosaur. Two reverse folds in a row. See the origami dinosaur and T-rex guide.
- Bird base models. The crane, a crane-based simple paper dragon and the T-rex introduce the square base and petal folds.
For an overview of difficulty levels and the bases behind animal models, see the origami animals guide.
Common beginner mistakes and fixes
- Soft, puffy creases. Press each fold with a fingernail or bone folder. Soft creases make later steps drift.
- Corners that don’t quite meet. Take a second to line them up before creasing. A millimeter off early on can become a centimeter off later.
- Folding in the air. Always fold on a hard surface until you’re experienced.
- Paper that’s too small or too thick. Use 15 cm or larger thin paper. Tiny or thick paper makes small folds very hard.
- Rushing reverse folds. Pre-crease, open the layers slightly, and guide the point. Don’t force it.
- Giving up after one try. Most models look much better on the second or third fold.
FAQ
What is the easiest origami for a beginner?
Simple face models such as a dog or cat face are among the easiest, at around four to eight folds. A traditional paper cup is another common first model.
What size paper should a beginner use?
A 15 cm (6 inch) square suits most beginner models. Young children often find 20 cm (8 inch) paper easier to handle.
Can I use printer paper for origami?
Yes, for simple models. Cut it into a square first. It’s thicker than origami paper, so it becomes hard to fold in models with many layers.
What age can children start origami?
Many children can manage simple folds, such as a triangle or a dog face, by around preschool or early school age with help. Models with reverse folds usually suit older children. Abilities vary, so start simple and let the child set the pace.