Two Small Birds, Two Simple Bases
Parakeets and quail are very different birds. A parakeet is slim, with a long pointed tail. A quail is round and compact, with a short tail and a small head. Those differences make them a good pair for learning how the choice of base shapes the finished bird.
- The parakeet below uses a kite base, which naturally produces one long, sharp point. That point becomes the tail.
- The quail uses a folded triangle, which has a deep, square corner. That corner becomes a full, rounded chest.
Both are beginner-friendly and need only a few inside reverse folds. If you haven’t done a reverse fold before, our easy origami bird step-by-step guide explains it in detail.
What You Need
- Square paper, about 15 cm (6 in). Origami paper colored on one side works well for both birds.
- Colors that suit each bird. Green, yellow or blue for a parakeet; brown, tan or gray for a quail.
- A fine-tip marker for eyes and markings.
- A hard, flat surface.
How to Fold an Origami Parakeet
This is a simple perched bird with a long tail, a small head and wings along its sides.
- Crease the center. Place the square as a diamond, white side up. Fold it in half from left to right, crease and unfold. You have a vertical crease down the middle.
- Fold a kite base. Fold the lower left edge in to meet the center crease. Do the same with the lower right edge. The paper now looks like a kite with a long, sharp point at the bottom.
- Fold in half. Fold the kite in half along the center crease, bringing the left side over to the right so the kite flaps end up on the inside. The colored side of the paper is now on the outside.
- Position the body. Turn the model so the long folded edge runs along the top. Put the long, sharp point on the left. That’s the tail. The shorter point on the right will become the head, and a corner hangs down underneath as the belly.
- Raise the head. Fold the right point upward so it stands up, with the fold line starting on the top edge a short way in from the tip. Crease, unfold and inside reverse fold it so the point rises between the two layers.
- Make the beak. Inside reverse fold a small section at the tip of the head downward. Keep it short; a parakeet’s beak is small and curved.
- Fold the wings. Take the hanging belly corner on the front layer and fold it up and back so it lies along the side of the body, pointing toward the tail. Repeat on the back layer.
- Angle the tail. Inside reverse fold the tip of the tail down slightly, or simply tilt the whole bird so the tail angles toward the ground, the way a perched parakeet sits.
- Add eyes. Draw a small eye on each side of the head.
The finished parakeet may not balance on its own. It looks good perched on the edge of a shelf, a pencil or a twig.
How to Make an Origami Quail
This quail uses the same folded triangle as the easy sitting bird, but turned the other way up so the deep square corner becomes the chest.
- Fold a triangle. Place the square as a diamond, colored side down. Fold the bottom corner up to the top corner and crease.
- Fold in half. Bring the left corner over to meet the right corner and crease firmly. You now have a small triangle with one square corner.
- Position the body. Turn the triangle so the edge you just folded runs along the top. The square corner should be at the top right. The sharp corner at the top left will be the tail, and the loose flaps hang down at the bottom right as the chest.
- Raise the head. Fold the square corner at the top right upward, with the fold line starting on the top edge a short way in from the corner and angling down to the front edge. Crease, unfold and inside reverse fold it so the corner rises between the layers. Keep the neck short; quail have small heads that sit close to the body.
- Make the beak. Inside reverse fold the very tip of the head forward and slightly down to make a small, blunt beak.
- Round the chest. Fold the bottom corners of the loose flaps inward, tucking them up inside the body. This takes away the sharp point at the bottom and gives the quail a plump, rounded front.
- Shorten the tail. Inside reverse fold the tip of the tail at the top left so it tucks inside the body or points slightly downward. A short, stubby tail is one of the things that makes a quail look like a quail.
- Add details. Draw eyes, and add simple markings such as dark spots or scaly lines on the body.
Optional plume. Some quail, such as California quail, have a distinctive teardrop-shaped plume on top of the head. You can draw one on, or cut a tiny teardrop from dark paper and glue it in place. Strictly speaking, gluing goes beyond pure origami, but it’s a simple way to add the detail.
Making Small Birds Look More Realistic
A simple fold can look surprisingly lifelike with a few small choices.
Pick the right colors. Pet budgerigars, often called parakeets, are commonly green and yellow, though blue, white and other colors are bred too. Many quail are mottled brown and tan. Matching the paper to the real bird does a lot of the work.
Get the proportions right. Tail length is one of the quickest ways to tell birds apart. Leave the parakeet’s tail long and pointed; keep the quail’s short. If a bird looks wrong, the tail or head size is often the reason.
Shape the body. Gently curve the back and round the chest with your fingers after the last fold. Flat models look stiff; a little curve suggests feathers and weight.
Mind the head angle. Small birds usually hold their heads upright and alert. A head tilted slightly forward or to one side can add character.
Use markings sparingly. A few lines or spots suggest feathers better than heavy coloring. Real budgies have wavy black barring on the back of the head and wings, while many quail have scaly or spotted patterns.
Consider two-tone paper. On many simple birds, the reverse side of the paper shows on part of the head or wings. Choose paper with a second color you’d be happy to see.
Troubleshooting
The head is too big. Make the head reverse fold closer to the tip so less paper goes into it.
The parakeet’s tail looks too thick. The kite folds may not have reached the center crease. Make sure both edges meet the center exactly in step 2.
The quail looks pointy, not round. Tuck more of the bottom corners inside in step 6, and gently push the chest outward with a fingertip.
The bird won’t stand. Small perched birds often don’t balance on their own. Set them on an edge, lean them against something or fold the bottom flatter.
Frequently Asked Questions
How do you make a parakeet out of paper?
The simplest way is the kite-base method above: fold a kite, fold it in half, reverse fold the short point into a head and beak, fold the belly corners up as wings, and leave the long point as the tail.
What’s the easiest origami animal to make?
Many beginners start with very simple models such as a dog face or a folded-triangle bird. Among birds, the easy sitting bird and the easy origami penguin are good first projects.
What is the hardest origami to fold?
There’s no single answer. Some modern designs use one uncut sheet and take many hours or even days, with very thin paper and hundreds of steps. Realistic birds with separate feathers or toes can fall into that category. The models on this page are deliberately simple by comparison.
For more birds to try, see our beginner’s guide to origami birds.