To make an origami bow tie with a dollar bill, accordion-pleat the bill along its length so the folds run parallel to the long edges, pinch the pleated strip in the exact middle, and wrap the middle with a narrow band (a second bill folded thin, or a ribbon). Then spread the pleats on each side so they flare out like a bow tie. It takes about five minutes.
The finished bow tie is about 6 inches (15 cm) wide and up to 2 1/2 inches (6.5 cm) tall at the ends, roughly the shape of a real bow tie.
What You Need
- One crisp bill for the bow
- For the knot, one of these:
- A second bill (the neatest all-money option)
- A short piece of narrow ribbon
- A twist tie, if you’ll hide it behind a gift or card
- A hard, flat surface
If you haven’t folded money before, see the dollar bill origami basics for how to prepare a bill.
Step 1: Divide the Bill Into Eighths
The pleats for a bow tie run the long way, so you’ll divide the bill’s height (its short side) into eight strips.
- Lay the bill flat with the long side horizontal.
- Fold it in half lengthwise, bringing the bottom long edge up to the top long edge. Crease and unfold.
- Fold the top and bottom long edges to the center crease, crease, and unfold. The bill is now in quarters.
- Fold the top edge to the nearest quarter crease and unfold. Then fold the top edge to the quarter crease below the center and unfold. Repeat from the bottom edge.
You should now have seven creases dividing the bill into eight equal strips, each about 1/3 inch (8 mm) tall.
Step 2: Accordion-Pleat the Bill
- Starting at the top edge, re-fold the creases one at a time, alternating directions: valley, mountain, valley, mountain.
- Flip any crease that’s pointing the wrong way as you go.
- When you reach the bottom, you’ll have a narrow pleated strip about 6 inches (15 cm) long.
- Squeeze the strip hard along its whole length to sharpen every pleat.
Step 3: Pinch the Center
- Bend the pleated strip in half end to end just enough to find the middle, then straighten it.
- Pinch the strip firmly at that middle point.
Getting the pinch right in the middle keeps both sides of the bow the same size.
Step 4: Wrap the Knot
With a second bill:
- Crease the second bill in half lengthwise and unfold. Fold both long edges to the center crease, then fold the strip in half along the center. Fold it in half lengthwise once more. You’ll have a narrow band about 1/3 inch (8 mm) wide.
- Lay the pinched bow across the middle of the band.
- Wrap the band around the pinch, keeping it snug. Wrap more than once if the band is long enough.
- Tuck the end of the band under the wrapped layers on the back.
With a ribbon: Tie a narrow ribbon around the pinch with a knot at the back, and trim or tuck the ends.
With a twist tie: Twist it tightly around the pinch at the back and fold the ends flat. This works best when the back won’t be seen.
Step 5: Spread the Bow
- Hold the knot and gently fan out the pleats on one side so the end opens wider than the middle.
- Repeat on the other side.
- Adjust both sides until they match.
Ways to Use a Dollar Bill Bow Tie
- Gift topper. Place it on a wrapped present instead of a ribbon bow.
- Father’s Day or graduation card. A flat bow tie slips inside a card.
- Wedding favors or tips. A bow tie made from a bill is a playful way to tip a band or DJ, or to dress up a money gift for a groom.
- Pair it with a shirt. A full-size bow tie is much wider than a dollar bill shirt. For a mini bow tie that fits under the collar, fold the bill in half end to end twice so it’s about 1 1/2 inches (4 cm) long, pleat the folded stack into quarters, pinch the middle, and spread the ends only slightly. A narrow ribbon bow also works.
Troubleshooting
The bow won’t fan out evenly. The pleats aren’t even. Re-crease using Step 1’s edge-to-crease method rather than folding by eye.
The knot slides off center. Wrap the band more tightly, or wrap it more times. A twist tie under the band can help hold the pinch.
The ends look too narrow. Spread the pleats wider at the ends, or pleat into fewer, wider strips (quarters instead of eighths) for a chunkier bow.
The same pleat-and-pinch idea is the base of the dollar bill butterfly and the three-bill money flower, so once you’ve made a bow tie, those are easy next steps.