Short Answer
To make a rectangle-shaped box from paper, start with a rectangular sheet and crease a border of equal width along all four edges. Along two opposite edges, crease a second border of the same width. Fold the walls up. The small squares at each corner fold inward into triangles. Then fold the double border down into the box over those triangles, which locks the corners. You don’t need glue, tape or a square sheet.
This tray method works with A4, US letter or any rectangle, and you choose the proportions of the box before you fold. Below are the planning formula, a full A4 walkthrough, a lid, and variations.
What You Need
- One rectangular sheet: printer paper, thin craft paper or wrapping paper. Standard origami paper is usually too small and too thin for this.
- A ruler and pencil, at least for your first box.
- A second, slightly larger sheet if you want a lid.
Plan the Box Size
Call the border width B. It becomes the height of the walls.
- Pick the two edges that get the double border. These become the locked walls.
- Across the double-border direction, the base is the sheet dimension minus 4B.
- In the other direction, the base is the sheet dimension minus 2B.
The corner squares fold flat against the locked walls, so B shouldn’t be larger than the length of those walls. In practice that only matters for deep boxes.
Examples:
| Sheet | Double border on | B (wall height) | Base | Shape |
|---|---|---|---|---|
| A4, 21 × 29.7 cm | Long edges | 3 cm | 9 × 23.7 cm | Long, narrow tray |
| A4, 21 × 29.7 cm | Short edges | 4 cm | 13 × 13.7 cm | Nearly square box |
| Letter, 8.5 × 11 in | Long edges | 1 in | 4.5 × 9 in | Rectangular tray |
The first row is a good pencil or cutlery-drawer tray, and it’s the one we’ll fold step by step.
Step-by-Step: Rectangular Tray from A4
This makes a tray about 9 × 23.7 cm with 3 cm walls.
- Lay the sheet landscape, pattern side down. The long edges run across the top and bottom. The side facing the table ends up on the outside of the box.
- Crease the double borders on the long edges. Measure and crease lines 3 cm and 6 cm in from the top edge, running the full length of the sheet. Do the same 3 cm and 6 cm in from the bottom edge. Fold each line with the paper turning up toward you, then flatten it again.
- Crease the single borders on the short edges. Crease a line 3 cm in from the left edge and 3 cm in from the right edge, running top to bottom.
- Find the corner squares. Look near each short edge. Where the 3 cm side line crosses the band between the 3 cm and 6 cm lines, there’s a 3 × 3 cm square. There are four of these, one near each corner of the sheet but one square in from the top or bottom edge.
- Crease the corner diagonals. In each of those four squares, fold a diagonal from the corner that touches the base area to the corner on the sheet’s short edge. Fold it both ways so it moves freely.
- Raise the walls. Fold up the short walls at each end, and fold up the long walls along the 6 cm lines, with the 3 cm strips beyond them still attached. As the walls meet, each corner square collapses inward along its diagonal into a triangular flap inside the box.
- Flatten the corner triangles. Press each triangle flat against the inside of the long wall next to it. The small piece of paper at the very corner of the sheet goes along with it and lies against the strip above the wall.
- Lock the long walls. Fold the 3 cm strip at the top of each long wall down into the box along the 3 cm line, covering the corner triangles. Its edge should reach the floor. Press it flat.
- Square everything up. Pinch the four vertical corners and crease the bottom edges from inside and outside.
The short walls are a single layer and the long walls are several, which is why the box keeps its shape even in thin paper.
Adding a Lid
Fold a second box with the same border width from a sheet about 5 mm larger in each direction. With A4, the simplest way is to trim the base sheet instead: cut it to about 20.5 × 29.2 cm and use a full A4 sheet for the lid.
The lid’s walls add a little thickness. If it’s tight, increase the difference a few millimeters at a time. If it’s loose, reduce it. For a shallow lid that only covers the top of the box, use a smaller border on the lid sheet and adjust the sheet size so the lid’s base still comes out just larger than the box’s base.
Variations
Deep Box or Pen Holder
For tall walls, make the border wide and put the double border on the short edges. Trim an A4 sheet to 18 × 29.7 cm and use B = 6 cm:
- Across the double border (29.7 cm): 29.7 − 24 = 5.7 cm.
- In the other direction (18 cm): 18 − 12 = 6 cm.
That gives a holder about 6 cm square and 6 cm tall, deep enough for pens and pencils. Here the border equals the length of the locked walls, which is the upper limit, so fold carefully. Our origami boxes and containers guide shows how to turn it into a kawaii animal pen holder with ears and a face.
Squarer Box from the Same Sheet
Put the double border on the short edges with B = 4 cm (second row of the table) for a box that’s close to square. For a truly square box from a square sheet, the masu box is the classic choice.
Sturdier Box from Cardstock
Cardstock is too stiff for the corner triangles and the locking strip. For a cardstock box, use the same layout but score the fold lines first with a blunt tool and a ruler, cut out the corner squares instead of folding them, and glue small tabs at the corners. That’s a papercraft box rather than origami, but it holds heavier items.
Tips and Troubleshooting
- Measure the first box, then make a template. Once one box works, mark the crease positions on a strip of card and use it to mark the rest.
- The corners spring open. The locking strip isn’t folded fully down. Make sure it reaches the floor. A tiny dab of glue under each corner triangle fixes it permanently.
- The walls bow outward. Re-crease the base lines sharply. Heavier paper helps with long walls.
- The box is lopsided. One border was creased at the wrong width. Use a ruler for all eight lines.
- You want something more decorative. Try a star box or a takeout-style box, which closes at the top.